
REAR SHOCK
Price
$890.00
● In stock
Quantity
Tarifa de muelle según peso del piloto. Compresión 7 posiciones, rebote 4 posiciones.
A piggyback rear shock built for electric dirt bikes that pile on hours of fast, technical riding. The FASTACE rear shock uses a separate compression / rebound piston layout with a high-flow piggyback reservoir, dual-stage compression, and a rider-weight-matched coil spring.
On the bench, every shock gets its damping verified against our reference curves. On the trail, the result is a shock that doesn't fade on long descents, doesn't pack on rapid hits, and doesn't feel disconnected from the rider's input the way many stock shocks do above 25 °C.
Direct-fit on the bikes listed below; no eyelet adapters, no relinkage required. Most installs take 30–45 minutes.
Ajuste directo en estas motos — sin adaptadores, sin hardware propietario.

Sur-Ron Light Bee
More control on hard hits fork · MORE ROOM FOR BIG IMPACTS shock

Sur-Ron Ultra Bee
More control on hard hits fork · MORE ROOM FOR BIG IMPACTS shock

Talaria Sting
More control on hard hits fork · MORE ROOM FOR BIG IMPACTS shock

Talaria XXX
More control on hard hits fork · MORE ROOM FOR BIG IMPACTS shock

E-Ride Pro SS
More control on hard hits fork · MORE ROOM FOR BIG IMPACTS shock
Pre-instalado según tu peso al pedir. Usa esta tabla si cambias el muelle más adelante.
| Peso del piloto (con equipo) | Tasa recomendada | Caso de uso |
|---|---|---|
| 60–75 kg | 400 lb/in | Trail riding, lighter rider |
| 75–90 kg | 450 lb/in | Most riders, default option |
| 90–105 kg | 500 lb/in | Aggressive enduro, heavier rider |
| 105 kg+ | 550–600 lb/in | Race / DH — contact us for valving |
La mayoría de instalaciones tardan 40–60 minutos con herramientas estándar de taller moto. Las instrucciones completas se entregan con el producto.
Support the bike under the swingarm and remove the rear wheel.
Remove the upper and lower shock bolts; lift the stock shock out.
Install the FASTACE shock with reservoir oriented away from the airbox / battery to avoid heat soak; torque to manufacturer spec.
Reinstall the rear wheel and swingarm hardware.
Set static sag to 30–40 mm with rider in full gear; adjust the preload collar.
Set rebound to 12 clicks from fully closed; low-speed compression to 10 clicks; high-speed compression to 1.5 turns from closed as a starting point.
Direct-fit on the bikes listed in the Fitment section. No eyelet shims, no linkage modification.
Yes. We size the spring and tune the compression / rebound to your weight + gear at the factory.
Yes — we mount the reservoir to clear all OE components on the supported bikes. If you've added an aftermarket battery enclosure, send us a photo before ordering.
Yes. The shock can be opened by any reputable suspension shop. We also offer a flat-rate revalve service from our Xi'an facility.
24 months from purchase against manufacturing defects. Crash damage, blown seals from impact and modifications by unauthorised parties are not covered.
Envíanos un clip de vídeo de tu terreno y tu peso; te responderemos con un ajuste inicial.